Procedure Entry Point Could not be located

  • Thread starter Thread starter James
  • Start date Start date
J

James

Greetings,

It's very likely that some other application you have
installed put an older version of scrrun.dll on your
system, causing this error.

Check the version number of the file on all of your good
Dells and compare it with those which are affected.

I believe, the version number on that file should be
5.6.0.6626.

The version in %windir%\system32 should still be the
correct one - it's a protected file, so it shouldn't have
been overwritten - you can probably just re-register it
and all should be well.

I'd strongly suggest that you choose a "unimportant" PC to
do this on AND backup the registry first!

Type "regsvr32 scrrun.dll" from any command prompt.

This should replace the "bad" version with the "good" one.

Kindest regards,

James
 
Back
Top