Problems upgrading from NT 4 to W2K Server

  • Thread starter Thread starter Ernest D. Stalnaker
  • Start date Start date
E

Ernest D. Stalnaker

I am trying to do something that seems like it should be simple.

I want to upgrade a small network I support from Windows NT 4.0 Server to
Windows NT 2000 Server, but when I try to set up the Windows 2000 server,
none of my clients can find the server in order to authenticate to the
Active Directory.

Here is my configuration under NT 4.0:

- A Linksys cable/DSL router controls access to the Internet, and also acts
as a DHCP server. The router dynamically obtains an address from the ISP.

- The local address of the router is 192.168.1.1.

- The local address of the Windows NT server is 192.168.1.2 (This is a fixed
address).

- The other computers on the network (a mixture of Windows 98/2000/XP) have
local addresses assigned dynamically by the router, ranging from 192.168.1.3
to 192.168.1.20.

- I have configured the primary and secondary DNS addresses on the router,
and it gives this information to each client when it assigns the local IP
address. I hardcoded the values for the server since it is a fixed address.
Each computer can access the Internet without any problems with the NT 4.0
server.

- The NT 4.0 server is not a web server, a DNS server, a WINS server, or any
other type of host. It just controls the domain and is a file/print server.
When I try to set up the same configuration using Active Directory on a
Windows 2000 server, none of the clients can even find the domain or active
directory. My 2000/XP workstations can't be added to the domain, and my 98
workstations can't log in either.

I have enabled Netbios over TCP/IP, so this should allow my clients to talk
to the server as if it were a Windows NT 4.0 server, isn't that correct?

Somebody told me that I needed to configure DNS on the Windows 2000 server,
but why would this be necessary? The server isn't controlling my domain,
and I don't want it to be a DHCP server. I want the router to dole out the
IP addresses, not the 2000 server.

If I do have to configure DNS, how should I do this? What are the exact
values I would use on the server and on the workstations?

I would appreciate any help that you can give me. I have installed Windows
2000 workstations numerous times, but have never set up a 2000 server in
this type of an environment before.

Thanks,

Ernest Stalnaker
 
Ernest,

I think Active Directory needs DNS to work properly. Someone else out there
can verify this. As far as setting it up, I'll let someone else handle that
one. Good Luck.

Mark
 
Back
Top