G
Guest
Hi
I'm simulating an ADS environment using Virtual PC 4.2 with the following setup
Gateway - 192.168.0.
DC/DHCP/DNS - 192.168.0.
ADS Controller - 192.168.0.
ADS Image Service - 192.168.0.
5 x Test Devices using DHC
I'm attempting to boot one of the test devices into the deployment agent using the default task sequence (boot-to-da). The DA boots OK but the controller and the device never acknowledge that they are connected to one another. I've checked times on both controller and test device - they are both in sync, so I don't think this is a certificate issue. Also, I turned on tracing and packets are coming to and from the controller and test device
Not really too sure where to go from here... Any ideas
Thanks
Dea
(remove no.spam from address to reply!
I'm simulating an ADS environment using Virtual PC 4.2 with the following setup
Gateway - 192.168.0.
DC/DHCP/DNS - 192.168.0.
ADS Controller - 192.168.0.
ADS Image Service - 192.168.0.
5 x Test Devices using DHC
I'm attempting to boot one of the test devices into the deployment agent using the default task sequence (boot-to-da). The DA boots OK but the controller and the device never acknowledge that they are connected to one another. I've checked times on both controller and test device - they are both in sync, so I don't think this is a certificate issue. Also, I turned on tracing and packets are coming to and from the controller and test device
Not really too sure where to go from here... Any ideas
Thanks
Dea
(remove no.spam from address to reply!