problem with system cloning tool

  • Thread starter Thread starter Radek Vican
  • Start date Start date
R

Radek Vican

Hello guys,

uf.. help me please ..
We'd like to clone final image to target system. - problem new ssid

We have added a component name System cloning tool but this tool is starting
during FIRST FBA start and delete fbreseal command from system.
I need to boot image first with simple FBA, then reconfigure system, add our
application and then prepare a final system with fbreseal command.
before next boot clone system to next disk and during boot of system on new
disk finalize this image with new SID

uf.. how to do it please ? any idea ?

yours
Radek
 
I think (if I remember) that fbreseal.exe is deleted only the second time
you use it. One time during the FBA, and other time after you've made
changes to your image. So fbreseal must be present on your hard drive after
FBA.

If that's not exact, you can copy fbreseal.exe from your Repository to your
target device and execute it again (command line)
Warning: if you do this, fbreseal.exe is not deleted after reseal your
device... (it's only deleted the second time you reseal like I said)
It works, I already test it.

I hope it help you.
Bye
 
Right, or at least that is also how I understand it and have used fbreseal
to modify and reseal after, so it should be there after the first boot. By
the way, I have been told that it is NOT recommended to keep resealing the
device as it causes unpredictable results. But you should absolutely be able
to do it like Jerome suggests.

Scott Figg
 
Thank you very much guys,

It was really simple ...

"This property specifies at which FBA phase the reseal operation occurs. By

default, this property is set to 12,000. If this value is set to 0, you must

start the reseal phase manually. You can specify phases other than 0 and

12,000 but only these two phases are supported. If the phase is set too

early, it may interfere with other FBA operations and produce unpredictable

results including a non-functional run-time image. If you set this property

to 0, only the cloning tools will be copied to the run-time image and the

cloning phase will not occur. To manually complete the cloning phase, open a

command prompt, navigate to the %Windir%\system32 directory, and then type

Fbreseal.exe."

Thanks a lot again

Radek
 
Back
Top