Problem running FBA on exiting image using M-Sys uDoc

  • Thread starter Thread starter Mark Kraft
  • Start date Start date
M

Mark Kraft

Hi,

I have a working image that we currently run on HDD.
I have recently acquired a sample of a USB uDoc from M-sys.

I have stepped thru the AP_DOC-1304 app note adding the USB uDiskOnChip
component to my existing image. I have rebuilt this and copied to the
partitioned device. I have not employed EWF and I am testing with a single
partition. FBA starts only to the point where I see the bar across the black
screen. It seems to stall here. The LED on the uDoc pulsing as if it is
doing something.



I am looking for suggestions as to what it might be doing or other steps I
need to take and may have missed.

Thank you

--
Mark Kraft
Design Engineer
Lehigh Electric Products Co.
Tel: 610-395-3386
Fax: 610-395-7735
email: (e-mail address removed)
website: www.lehighdim.com
 
What color is the LED flashing? If green you have USB 1.1 boot and it will
take some time to load. If orange, then you have USB 2.0 boot and there is
something that is missing.

Regards,

Sean Liming
www.sjjmicro.com / www.seanliming.com
XP Embedded Book Author - XP Embedded Advanced, XP Embedded Supplemental
Toolkit
 
Hi Sean,


The USB is 1.1 color is green. I had some feeling about his. What will boot
time be like compared to HDD using this on 1.1?

Thanks

Mark
 
Back
Top