Problem: A drive does not see floppy

  • Thread starter Thread starter oldman
  • Start date Start date
O

oldman

When I insert a floppy disk in my a drive I get the following message:
No ID address mark found on floppy disk. The drive is not
accessible. (This was done with floppy I used to load the Gigabyte
drivers) Drive was setup as shared but still nothing. Does anyone
have any ideas what is wrong?

TIA
 
Hi,

A Google search reveals many hits on this problem. I'd suggest reading over
several of these and possibly find a solution for you. In Google type in....
No ID address mark found on floppy disk

All the best,
SG
 
SG

Followed your suggestion and did a Goggle search. Tried some of the
suggestions, i.e., changed ribbon cable, uninstalled the floppy
driver, Vista 32x installed the driver on next reboot, used several
different floppies, tried to reformat the floppies, tried a freshly
reformatted flopped done on my XP system but still no go. Saw my
question posted in the Vistax64.com. I assume that the Vista 64
should would work the saw as Vista 32 in this case. Tried to force
the system to boot via the floppy by changing bios setup order this
did not work.

The floppy drive has been in the system for less than 6 months and was
used to install the Gigabyte device drivers. Yesterday was the first
time since the system setup that the drive was used. The problem can
not be age or usage. Since the desktop is sitting on top of the desk
away from the floor there is little chance of it getting dirty/dust
inside the unit.

Still no luck hoping for a suggestion to get this to work.

TIA
 
Could you have any third party anti virus, system protection etc software
installed that has 'disabled' the floppy?
If you are in a domain, group policy can disable the floppy.

Michael
 
Michael,

I am running PC-cillian Security package. I am running Home network
security at Minimum. The a drive is set to share and security is
anyone can access. I even added myself as a separate permission. But
still no luck.

I am not sure what you mean with in a domain. Please expand if
possible.

Thanks,
 
In a business environment your 'personnel' computer joins the domain of all
the computers controlled by the business. As part of this domain joining the
administrator of the domain (the business) has control of many aspects of
your computer. If your system is a stand alone home network computer without
being part of a large business that possibility doesn't apply.

The protection is to prevent anyone from copying data to USB thumb drives or
floppy drives and walking away with the data.

A quick look at PC-cillin site doesn't mention any protection from floppy
use.

If you cannot get the BIOS to boot from it, it sounds like hardware problems
in the drive. About the only way to check for sure is of course to swap in a
'known good' one.

Normally the floppy is NOT shared, you might unshare it to see if problem
goes away.


Sorry, I don't have any more ideas for you. When you do get your problem
cleared up be sure to get back so the next person with the problem can
benefit from your efforts.

Michael
 
Don't be fooled by new hardware my friend. I've been in business to long to
know that even right of the box has and can be defective. A floppy drive is
very cheap these days and worth the price to by one and try it. Here's one
for $4.88 http://www.gizmos2go.com/product.php?productid=582&MMCF_Nextag

See if you have a friend that would let you borrow theirs and see if that is
indeed the problem. I'm betting it is.

All the best,
SG
 
Ok the solution was to replace the A drive with a new one. Once
hooked and connected the problem went away. For about $12 delivered
it was money well spent.

oldman
 
Back
Top