Printing Issues

  • Thread starter Thread starter Bill k
  • Start date Start date
B

Bill k

I have a new design jet , that works on all my computers expect the one. So I
knows it’s something in the os’s side that could be causing issues, hooked it
up to usb and still the same , we know its not network issues, also
reinstalled the driver still the same.
What happens is that it seems to hang in the que when printing from autocad
, then when we print in adobe it gets to almost the end but cuts the job off
short.

Any ideas thanks
Bill
 
Bill k said:
I have a new design jet , that works on all my computers expect the one.
So I
knows it’s something in the os’s side that could be causing issues, hooked
it
up to usb and still the same , we know its not network issues, also
reinstalled the driver still the same.
What happens is that it seems to hang in the que when printing from
autocad
, then when we print in adobe it gets to almost the end but cuts the job
off
short.

I would suspect a lack of disk space for the temporary files. Printing high
resolution and/or large format files can take a very large amount of disk
space. You might try printing the same files but specify draft mode or
print at a lower resolution. If this allows the files to print it would
further confirm disk space as an issue.

Regards,
Bob Headrick, Microsoft MVP Printing/Imaging
 
Back
Top