Printing CDs with SMAAALL HOOOLES - Pixma 4000

  • Thread starter Thread starter BD
  • Start date Start date
B

BD

Hey, all.

I just bought some Taiyo Yuden printable DVDs, and was pleased to see
that the printable surface goes to about 5mm away from the inner hole
of the disk. Nice.

I want to be able to print all the way in that far, but the default
templates I've seen in Acoustica and Surething labelers just don't go
that far.

Anyone know of a way to make a new 'template' in Acoustica, which will
print to the full width of a disk, and in as far as I want?

The Layout panel in Acoustica has a 'hole hugger' layout, which - on
the layout selection panel along the left - shows a very small hole.
But when I select it, the hole is the standard size - about 1.5cm from
the inner edge of the disk surface.

Just curious if these inner edges of the labels can be adjusted. I
can't see a way so far.

Thanks!

BD
 
BD said:
Hey, all.

I just bought some Taiyo Yuden printable DVDs, and was pleased to see
that the printable surface goes to about 5mm away from the inner hole
of the disk. Nice.

I want to be able to print all the way in that far, but the default
templates I've seen in Acoustica and Surething labelers just don't go
that far.

Anyone know of a way to make a new 'template' in Acoustica, which will
print to the full width of a disk, and in as far as I want?

The Layout panel in Acoustica has a 'hole hugger' layout, which - on
the layout selection panel along the left - shows a very small hole.
But when I select it, the hole is the standard size - about 1.5cm from
the inner edge of the disk surface.

Just curious if these inner edges of the labels can be adjusted. I
can't see a way so far.

Thanks!

BD
Click to expand...

I haven't tried doing this except right now to look but on acoustica
if you look at the end of the window where it says Canon ip4000 full
face etc etc you should see a little icon, it has two tiny red ticks
on it or something. When i click this on mine it opens a printer/paper
template adjuster, has settings for the hole diameter etc... hope this
works for you :O)
 
I haven't tried doing this except right now to look but on acoustica
if you look at the end of the window where it says Canon ip4000 full
face etc etc you should see a little icon, it has two tiny red ticks
on it or something. When i click this on mine it opens a printer/paper
template adjuster, has settings for the hole diameter etc... hope this
works for you :O)
Click to expand...

Yup, I bet that's it.

Thanks, Paul! ;)
 
Back
Top