Print labels created with Label Wizard

  • Thread starter Thread starter Joyce
  • Start date Start date
J

Joyce

When I try to print labels I had designed in Access 97 or
labels I created in Access 2002 with Label Wizard, I get
a message that there is not enough horizontal space for
the columns I have specified. However, page setup is
correct.
 
When I try to print labels I had designed in Access 97 or
labels I created in Access 2002 with Label Wizard, I get
a message that there is not enough horizontal space for
the columns I have specified. However, page setup is
correct.
Click to expand...

You get the message, but the report still prints OK?
The size of the columns plus the margins and the width of the space
between the columns is greater than the width of the paper.

Make the right margin smaller.
Make the label width a bit smaller.
Set the column spacing a bit smaller.
Trial and Error is needed.
Or just ignore the message, as long as you get all the data.
 
-----Original Message-----


You get the message, but the report still prints OK?
The size of the columns plus the margins and the width of the space
between the columns is greater than the width of the paper.

Make the right margin smaller.
Make the label width a bit smaller.
Set the column spacing a bit smaller.
Trial and Error is needed.
Or just ignore the message, as long as you get all the data.

--
Fred

Please reply only to this newsgroup.
I do not reply to personal e-mail.
.
I don't get all the data and I have tried making all the
Click to expand...
reductions you suggested. Thanks for your suggestions
though. I have been on the phone with Microsoft support
for two hours, and they can't figure it out either. They
are going to call me tomorrow.
 
Back
Top