PPV2003 Automation stops after goto.

  • Thread starter Thread starter Billy
  • Start date Start date
B

Billy

Using the PPV2003.

Presently if you have already viewed a slide or partially
viewed a slide and go back to it using '1' Enter, it will
go right where it left off, advance through any remaining
builds, and then stall or wait until you hit another key?

Why does it finish its current builds and then stall?

Is there a way to go to a slide and have it reset to the
top of the slide at the same time?
 
Billy,

Sounds like VBA?

I do know generally that if you go back to a slide that has already run, it
will go to the end of all animations. The workaround is to insert a blank
slide before the target slide with timing set to zero. It will jump to the
next slide automatically at the start of all builds. HTH's.

--
Regards,

Glen Millar
Microsoft PPT MVP
http://www.powerpointworkbench.com/
Please tell us your ppt version, and get back to us here
Remove spaces from signature
 
Back
Top