PL-IP3/T Upgrade Kit on P2B

  • Thread starter Thread starter Malcolm Edwards
  • Start date Start date
M

Malcolm Edwards

Hi

I have just ordered a Powerleap PL-IP3/T upgrade (with celeron 1.4 GHz chip)
to upgrade my PIII 500 CPU (itself upgraded from the original PII 300) on a
P2B (Rev 1.02).

The manual on the web site mentions that all jumper settings are taken care
of on the CPU card.

Can anyone tell me if there are any settings I need to change on the
motherboard, or can I just leave the FSB and multiplier as they are?

Thanks.

Malcolm.
 
Malcolm said:
Hi

I have just ordered a Powerleap PL-IP3/T upgrade (with celeron 1.4 GHz chip)
to upgrade my PIII 500 CPU (itself upgraded from the original PII 300) on a
P2B (Rev 1.02).

The manual on the web site mentions that all jumper settings are taken care
of on the CPU card.

Can anyone tell me if there are any settings I need to change on the
motherboard, or can I just leave the FSB and multiplier as they are?
Click to expand...

You can leave everything as-is, just the last BIOS (1014 beta 3) will be
needed.

Stephan
 
Excellent.

Thanks Stephan.

Malcolm


Stephan Grossklass said:
You can leave everything as-is, just the last BIOS (1014 beta 3) will be
needed.

Stephan
--
Meine Andere Seite: http://stephan.win31.de/
PC#6: i440BX, 2xCel300A, 512 MiB, 18+80 GB, R9k AGP 64 MiB, 110W
This is a SCSI-inside, Legacy-plus, TCPA-free computer :)
Reply to newsgroup only. | See home page for working e-mail address.
Click to expand...
 
Hi

I have a similar setup, except with the 1.3GHz processor. Been running for
years without any problems. At one stage I had the processor running at
1.5GHz without any problems. I have since upgraded, and my wife uses the
older PC now, I am still amazed at the speed.

Regards

Brett
Excellent.

Thanks Stephan.

Malcolm
 
Back
Top