PenMount touchscreen problem

  • Thread starter Thread starter Ali.Incekara
  • Start date Start date
A

Ali.Incekara

Hello all,
have somebody experience with PenMount touchscreen in XPE.
I tried to excute the installation setup programm after fba,
but it breaks without any error message.
should i creat component from the driver?
which components i need additionaly?
can somebody help me?

thanks and best regards,

Ali Incekara
 
Have you tried installing it on my Vampire.slx, available
on xpefiles.com (use the dated one, not the 'vampire
latest'), which is as full a build as you can get. If you
can't get it to work on there, you know a missing software
component isn't you issue.
 
Ali,

I tried (and failed miserably) to componentise the Penmount Touchscreen
drivers. I ended up with a component which when included in a build results
in the Penmount Install set being on the system after FBA. I then run the
installation and it works fine. So I suggest something is missing from your
build which is stopping the Penmount install working. Heidi's suggestion of
trying it on her "vampire" build should prove this.

Regards,
Andy
 
Hello Andy and Heidi,
thanks for the information.
I add the Windows Installer Service to the Image.
know its is posible to run the Installation Setup after FBA.
It's working know.
Thanks ....
 
Back
Top