P4P800 SATA RAID problems

  • Thread starter Thread starter moe32things
  • Start date Start date
M

moe32things

I have a P4P800 and two Maxtor 6Y200M0 SATA drives and I'm trying to run them in RAID 0 and have all the correct settings in the BIOS but still never see the "press CTRL+I for RAID configuration", so I found the program on the cd and put it on a floppy and ran it, but I only see one of my drives when both are connected. But if i connect each one individually I see it, but never both together. If someone could help me out that would be great.

TIA,
Tim
 
I've got a P4C800-E Deluxe but yours may be similar... Hope it helps!

On this Board you need to connect to the SATA1 and SATA2 connectors
and in the BIOS set:

Onboard IDE Operate Mode [Enhanced Mode]
Enhanced Mode Support On [S-ATA]
Configure S-ATA as RAID [Yes] <---
Serial ATA BOOTROM [Enabled] <---- these get you the CTRL+I
prompt

moe32things said:
I have a P4P800 and two Maxtor 6Y200M0 SATA drives and I'm trying to run
Click to expand...
them in RAID 0 and have all the correct settings in the BIOS but still never
see the "press CTRL+I for RAID configuration", so I found the program on the
cd and put it on a floppy and ran it, but I only see one of my drives when
both are connected. But if i connect each one individually I see it, but
never both together. If someone could help me out that would be great.
 
Back
Top