P4C800-E Deluxe Raid Question

  • Thread starter Thread starter Tom Bidwell
  • Start date Start date
T

Tom Bidwell

The manual for my new P4C800-E Deluxe says that to set up a RAID 1
array I need 2 PATA drives and 1 SATA drive. I was under the
impression that all I needed was 1 SATA and 1 ATA. Is this a mistake
in the manual?

Thanks
 
For a RAID 1 setup, you typically would use two SATA drives on the Intel
Controller for optimal performance. You could also use a pair of SATA
drives on the Promise controller, but why would you unless you already had a
boot drive on the Intel controller.

You could also put a pair of PATA drives on the Promise controller in either
RAID 1 or RAID 0.

And of course you could do something like Raid 0+1.

Good Luck!
 
Back
Top