over clocking p4c800 help

  • Thread starter Thread starter Nige
  • Start date Start date
N

Nige

Hi all

New to o/clocking ,
can manage 10% o/clock on p4 3gig p4c800
but anymore causes system to hang,
would passive heatsinks on chipset and better cooling
on cpu help?

btw cpu is currently 48c

thx nige.
 
Hi all

New to o/clocking ,
can manage 10% o/clock on p4 3gig p4c800
but anymore causes system to hang,
would passive heatsinks on chipset and better cooling
on cpu help?
Click to expand...

Is your ram capable of running faster than 200 MHz ? Pc3200 is
specified for fsb200 or DDR400.

If not, then set up in bios an asynchroneous ram speed where ram runs
slower than fsb.

I suppose pci and agp speed is either locked or not any problem by 10%
OC.

If cpu temp. is 48C during idle, I would say that this is not very
low. It could be lower. It might very easily increase above 55C and I
have seen such a temperature cause locking.

best regards

John
 
thx for reply john.

my idle cpu temp is 35c, 50c under load.
and i have 3200 mem 1 gig.
have not checked pci/agp speed,
new to this so just tried 10% o/clock.

thx again,

nige.
 
Back
Top