Okidata ML 320 and W2k Pro

  • Thread starter Thread starter Dan
  • Start date Start date
D

Dan

I have a custom form (6" wide and 2" length)which I am trying to print
from a Windows 2000 Pro to a Okidata ML 320. I have the form setup
correctly but the printer feeds approximately 11" in between each
form. Does anyone have any suggestions as to why this is happening? I
have tried all the latest drivers, etc but cannot correct the length
it is feeding between forms.

Dan
 
Dan said:
I have a custom form (6" wide and 2" length)which I am trying to print
from a Windows 2000 Pro to a Okidata ML 320. I have the form setup
correctly but the printer feeds approximately 11" in between each
form. Does anyone have any suggestions as to why this is happening? I
have tried all the latest drivers, etc but cannot correct the length
it is feeding between forms.
Click to expand...

Use the front panel controls on the printer itself to go into setup
mode. Make sure it doesn't have any sort of automatic form feed
enabled. They may call it something else...
 
Back
Top