G
Guest
Hardware is all OEM., WinXP Homeon 80G hard drive, 210 W power supply, only
add-in card is a Linksys Wireless-G PCI card. It was running with a 2GHz
Celeron@400MHz FSB w/a SiS 651 Chipset. Chipset supports 533MHz FSB.
Everything was functioning fine b4 I swapped the 2GHz Celeron with a 3.06GHz
[email protected] is ALL I did. From that point on I get no post beep
nad not output/input to the monitor. I tried switching baclk to the 2GHz
chip, still the same. Any ideas as to what may b wrong?
add-in card is a Linksys Wireless-G PCI card. It was running with a 2GHz
Celeron@400MHz FSB w/a SiS 651 Chipset. Chipset supports 533MHz FSB.
Everything was functioning fine b4 I swapped the 2GHz Celeron with a 3.06GHz
[email protected] is ALL I did. From that point on I get no post beep
nad not output/input to the monitor. I tried switching baclk to the 2GHz
chip, still the same. Any ideas as to what may b wrong?