No answer from Sony on this one! :-(

  • Thread starter Thread starter James D
  • Start date Start date
J

James D

Still can't figure out why my new Sony DRU-510A 4X DVD burner won't burn
DVD's higher than a 2X speed? I've used 2x
up to/and 4x blank discs but I still get a message that tells me it can only
burn at 2x instead of 3x. I've gotten this with all media I have tried. Is
there
a setting I need to adjust somewhere? The burns complete ok, just want to
know why the speeds are slower than I thought. Thanks.
 
Still can't figure out why my new Sony DRU-510A 4X DVD burner won't burn
DVD's higher than a 2X speed? I've used 2x
up to/and 4x blank discs but I still get a message that tells me it can only
burn at 2x instead of 3x. I've gotten this with all media I have tried. Is
there
Click to expand...
a setting I need to adjust somewhere? The burns complete ok, just want to
know why the speeds are slower than I thought. Thanks.
Click to expand...

I would check to see if everything is ok. You know install aspi layer
4.60+ , check it under the IDE controller - DMA mode etc

Then of course see if you have the latest firmware the obvious thing ,
and use the media they recommend.

And use CD speed at the NERO site to see if everything is running OK,
You can try HD tach to see if you Hard Disk is OK .

The other thing is trry it on another system to see if it works OK .
If not send it back.
 
James D said:
Still can't figure out why my new Sony DRU-510A 4X DVD burner won't burn
DVD's higher than a 2X speed?
Click to expand...

What kind of computer do you have? If you don't have the processing power to feed the drive at
4X, it will default to 2X (or worse).

Jon
 
I just upgraded from a P4 1.6 to a P4 2.0 with 896 MB RAM and it still
burns at the same 2X speeds.
 
What kind of computer do you have? If you don't have the processing power to feed the drive at
4X, it will default to 2X (or worse).

Jon
Click to expand...

By modern standards any computer has a fast enough CPU... UDMA allows
minimal CPU requirement, it's more important to have a relatively modern
source (HDD).
 
I just upgraded from a P4 1.6 to a P4 2.0 with 896 MB RAM and it still
burns at the same 2X speeds.
Click to expand...

Did you check for a firmware upgrade to the burner?


Have a nice week...

Trent

Follow Joan Rivers' example --- get pre-embalmed!
 
Back
Top