New Monitor

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I've added a new Viewsonics LCD Monitor. My computer (Presario 6000) seems
to be working fine but when it shuts down an error message flashes on the
monitor, "RBG no input signal" How do I fix this? Thanks
 
CG said:
I've added a new Viewsonics LCD Monitor. My computer (Presario 6000)
seems to be working fine but when it shuts down an error message
flashes on the monitor, "RBG no input signal" How do I fix this?
Click to expand...



There's nothing to fix. When the computer shuts down, the monitor is no
longer receiveng a signal from it. The monitor (not the computer) is just
telling you that.
 
That's normal. The computer shuts down before the monitor so the
monitor gives the message that it is receiving no "RGB Signal" from the
computer, then it goes into power save mode. When it receives signal
from the computer it wakes up again. While the computer is shut down if
you power off and then power on the monitor again you will get the same
message before it goes into power save again.

John
 
Turn it back on again, if it happens again when shutting down...turn it back
on again...repeat over and over.

Sorry couldn't resist!

It's normal don't worry about it.

:-)



| I've added a new Viewsonics LCD Monitor. My computer (Presario 6000)
seems
| to be working fine but when it shuts down an error message flashes on the
| monitor, "RBG no input signal" How do I fix this? Thanks
| --
| CG
 
CG said:
I've added a new Viewsonics LCD Monitor. My computer (Presario 6000) seems
to be working fine but when it shuts down an error message flashes on the
monitor, "RBG no input signal" How do I fix this? Thanks
Click to expand...


It's not an error; there's nothing to fix. It's your monitor telling
you that it's no longer receiving a signal from the shut-down computer.


--

Bruce Chambers

Help us help you:



They that can give up essential liberty to obtain a little temporary
safety deserve neither liberty nor safety. -Benjamin Franklin

Many people would rather die than think; in fact, most do. -Bertrand Russell
 
I've added a new Viewsonics LCD Monitor. My computer (Presario 6000)
seems to be working fine but when it shuts down an error message
flashes on the monitor, "RBG no input signal" How do I fix this?
Thanks
Click to expand...

I take it your replacing a CRT monitor. I recommend you look at
'ClearType'. This is MS's font tweaking program, which gives it's best
results on an LCD. You can turn it off if you so desire.

http://www.microsoft.com/typography/cleartype/tuner/Step1.aspx
 
Has nothing to do with the OP's problem.....
Click to expand...

The OP has no problem anyway. I was just pointing out a utility that may be
useful after just switching to an LCD monitor.

It makes a huge difference on some LCD screens.
 
Back
Top