network settings?

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

hi all,
i've just upgraded to vista ultimate from xp, and now i'm not able to direct
connect an instrument via NIC (cross-cable); it is using a fixed IP, this is
a tool for my job and previously was working fine in xp; the dedicate SW to
use this is ok, until I try to connect it (firewall disabled also), then it
gives me a connection failure message.
I've also tried to set those net in the private category, but it remain as
'limited connectivity', my impression is that the SW does not see any valid
network because of a prompt response...
any suggestion?
 
You may try to re-configure the NIC. This post may help,

Solved: Limited connectivity with Vista notebook
http://chicagotech.net/netforums/viewtopic.php?t=246


Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com
hi all,
i've just upgraded to vista ultimate from xp, and now i'm not able to direct
connect an instrument via NIC (cross-cable); it is using a fixed IP, this is
a tool for my job and previously was working fine in xp; the dedicate SW to
use this is ok, until I try to connect it (firewall disabled also), then it
gives me a connection failure message.
I've also tried to set those net in the private category, but it remain as
'limited connectivity', my impression is that the SW does not see any valid
network because of a prompt response...
any suggestion?
 
Back
Top