Network printer wont work.

  • Thread starter Thread starter Peter Jason
  • Start date Start date
P

Peter Jason

I have upgraded my ii net modem and now the
network printer will not work.
Is it necessary to change some setting within the
printer properties on a change of modem?
Peter
 
Grinder said:
In my first reply, I spent a lot of time talking about a router when
your original question was about a modem.

The trend for ISPs, around here anyhow, is to dispense a modem/router
combo in one unit. So, my apologies if your network is in fact two
discrete devices: a modem and a router. In that case, my speculations
would probably not be correct.

Perhaps it would helpful if you sort of diagrammed your network,
complete with makes and models of its components.
Click to expand...

Just out of curiosity, I found an "iiNet" page.

http://www.iinet.net.au/hardware-and-software/modems-and-routers.html

Maybe it's a "BoB2" ?

http://bc.whirlpool.net.au/bc/hardware/?action=h_view&model_id=1194

Paul
 
You may have been tripped up by DHCP.

A typical home network is set up so that all of the network
clients--desktops, laptops, tablets and printers--get their ip address
from a router. This is convenient, as the router can make sure to avoid
conflicts in those addresses.

Unfortunately, some printer drivers are not terribly savvy about finding
a network printer. They just assume it will be at the same ip address
where the first saw it, during installation.
Click to expand...

I have tried to change the IP address with the
"Wan" address (that I assume is what you mean) but
no luck. I use the iinet modem as a network hub.
I have tried reinstalling the printer software
"Samsung CLX6210 FX" but this "cannot find" a
network printer; and then refuses to accept a
manual entry IP address.
I am getting the Printer serviced (long overdue)
tomorrow an I specified a serviceman who knows how
to configure the thing.

In the mean time I got it working via the USB
option. I prefer the network attachment because
the printer is far away in the next room.
Some routers are pretty good about trying to hand out the same ip
address to the same device, some are not. If you replace a router, it
won't have any of that historical knowledge *and* may well hand out ip
addresses in a different range.
Click to expand...


My IP service provider "Netspace" has been taken
over by "Iinet", and now there's a "call centre"
with Asian women with austere unintelligible
voices who are too specific with their advice and
know nothing about networks and printers.
Look at whatever utilities might have been installed with your printer
driver. There maybe a "Reassign IP Address" utility, or command in one
of those utilities.

If nothing else, you can probably uninstall/reinstall the printer driver
again.
Click to expand...

Didn't work.
 
Not what I meant. I'm not sure what you tried there, but it doesn't
sound right.

If you were to tell us specifically what networking equipment and
printer you have, and how they are physically connected that would be
helpful.
Click to expand...

It's working again. There was some conflict with
the Printer & modem addresses. I found someone
who used the "TeamViewer" remote access program
and he made some adjustments to various fields;
and I'm more confused than ever.
 
Back
Top