Network Card replacement on w2k Cluster

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

Anybody done this recently and what is the best method
without breaking the cluster. I want to use a Fibre
Gigabit NIC instead of a Copper 100\Full NIC in both
cluster nodes. Both cards are in the nodes and now i want
to make the switch to the Gigabit card to use it for
public access to the Virtual machines. Exchange 2003 and
file\print run on the cluster balanced across nodes. What
is simplest way to do the change ? I want to keep the
same ip address.
 
Wish we could say there's an clean and easy way of doing this, but there's
not. See if article listed below 267548 shed's some light over the matter.

267548 Cluster IP Resource Fails with Event ID 1048 After Network Change
http://support.microsoft.com/?id=267548

Keep in mind, it would be best to leave the Private "Heartbeat" NIC 100\Full
Duplex as per article listed below 258750.

258750 Recommended Private "Heartbeat" Configuration on a Cluster Server
http://support.microsoft.com/?id=258750

--
Hope this helps,
Mike Rosado
Windows 2000 MCSE + MCDBA
Microsoft Enterprise Platform Support
Windows NT/2000/2003 Cluster Technologies

**Please do not send e-mail directly to this alias. This alias is for
newsgroup purposes only***

This posting is provided "AS IS" with no warranties, and confers no rights.
<http://www.microsoft.com/info/cpyright.htm>

Delighting customers is our top priority. We welcome your valuable comments
and suggestions about how to improve the service we provide you. So if you
would like provided us feedback, feel free to e-mail my manager Brian
Pennington then click on the following e-mail hyperlink with a short
statement with regards to your Online support experience
<mailto:[email protected]?subject=Newsgroup_Experience&body=Brian,>.
Thank you.

-----Original Message-----
 
Did the replacement last night. Easier than i had 1st
thought. moved cluster resources to one node took offline
important virtual machines e.g. file\print & Exchange.
Other node Set Cluster service to manual (not sure i
really needed to do this but) disabled old nic cleared ip
settings input ip settings on gigabit fibre card enabled.
Cluster services renames card to correct name restarted
server. Server up did ping test started cluster service
moved cluster groups brought online successfully. set
cluster to automatic. Did the same on other node. Not so
difficult.

Thank you for the reply.
-----Original Message-----
Wish we could say there's an clean and easy way of doing this, but there's
not. See if article listed below 267548 shed's some light over the matter.

267548 Cluster IP Resource Fails with Event ID 1048 After Network Change
http://support.microsoft.com/?id=267548

Keep in mind, it would be best to leave the
Click to expand...
Private "Heartbeat" NIC 100\Full
 
Back
Top