need Blank column in invoice

  • Thread starter Thread starter Frank
  • Start date Start date
F

Frank

Hi,
How can I make(or hide) contents of cell unless the cell before it isfilled
in? Hope i said that right. My invoice has a payment col and balance col
next to each other,. I want to have the formula in the balance column all
the way down, but it should be emty until a payment is filled in?
Thanks
Frank
 
Frank

Trap for no entry in the payment column by entering a formula in the balance
column.

=IF(payment_cellref="","",balance_formula)


Gord Dibben MS Excel MVP
 
Gord,
Thank you, but I already have the balance minus payment formula in the
balance col? How can I put both? formula is simple like =(d3-c4) where d is
the balance and c is the payment.Sorry for the very basic question.
thank you
Frank
 
Don,
If I understood what he meant, I would not have posted again. I am not an
idiot, just new to excel.
Frank
 
he meant if there was not a value in the cell show a blank,otherwise show
the formula.
 
Well Don,
Thanks for trying, but at this point I will give up and suffer through what
I have set up already. You see, I understand what his formula is saying,
sort of, but I do not understand where it goes. If I put it in a cell in the
balance column, then I have no formula for sutracting the pymt from the
balance.Maybe I am describing it wrong, very possible indeed.
Col A is the date of pymt.(no formula, just formatted for date)
Col B is the payment .(no formula, just formatted for currency)
Col C is the remaining balance with the formula for subtracting pymt from
beginning balance, leaving value of remaining balance in col C..
Whew!!
Thanks for trying,
Frank
 
Frank

A few assumptions...........

You have a payment in B1 of $123

You have a starting balance in C1 of $562

In C2 enter =IF(B1="","",C1-B1)

Drag/copy that formula down a ways then start pounding payments into column B


Gord
 
Hurray, It Works!
Thanks Gord and thanks to Don also. I am studying as much as I can so I can
understand better.
frank
 
Frank,

Earlier, in one of your posts, you mentioned that you use the Club Connect
Software at work. I am trying to find out if there is any sort of softcopy
documentation available for it.

I can explain more in detail offline if you would like.

Thanks.....
 
Back
Top