my laptop wont repair

  • Thread starter Thread starter bella
  • Start date Start date
B

bella

hello All,
Im having trouble agian with my laptop.when i turn it on its stating that i
need to launch start up repair,or start windows normally, windows failed to
start,due to a recent software or hardware problem.After trying both ways it
comes up with the same message on a blue screen, the installed program cannot
start,click ok to turn off the computer.And then i can not get anywhere.I
have a systerm recovery disk which display boot menu so i press enter it goes
back to lauch repair.
I have had the laptop wiped and started agian before but its happen agian
can anyone help me to learn how to do this instead of going to a shop for
this help?
thank you
 
bella said:
Im having trouble agian with my laptop.when i turn it on its
stating that i need to launch start up repair,or start windows
normally, windows failed to start,due to a recent software or
hardware problem.After trying both ways it comes up with the same
message on a blue screen, the installed program cannot start,click
ok to turn off the computer.And then i can not get anywhere.I have
a systerm recovery disk which display boot menu so i press enter it
goes back to lauch repair.
I have had the laptop wiped and started agian before but its happen
agian can anyone help me to learn how to do this instead of going
to a shop for this help?
Click to expand...

Sounds to me like you actually *have* a hardware issue that is causing this
trouble or you repeated whatever got you into this last time. More than
likely this is a hard disk drive or memory issue.
 
Shenan Stanley said:
Sounds to me like you actually *have* a hardware issue that is causing this
trouble or you repeated whatever got you into this last time. More than
likely this is a hard disk drive or memory issue.
Click to expand...
Have you tried to start up in safe mode? Have you checked for memory issues
x86 is a good tool to use for that. Also if you can boot in safe mode look
at the vent viewer under system and set a filter for disk, to se if there are
any bad block errors being report from the hard drive.
 
Back
Top