moving a system disk to another computer

  • Thread starter Thread starter 2xtapper
  • Start date Start date
2

2xtapper

I followed this KB article with no success

Article ID 314082
You receive a Stop 0x0000007B error after you move the Windows XP system
disk to another computer

Anyone ever moved an XP system disk to another computer and been able to
Boot?
 
2xtapper said:
I followed this KB article with no success

Article ID 314082
You receive a Stop 0x0000007B error after you move the Windows XP system
disk to another computer

Anyone ever moved an XP system disk to another computer and been able to
Boot?


Not unless the two computers were virtually identical, no.

Normally, and assuming a retail license (many factory-installed OEM
installations are BIOS-locked to a specific chipset and therefore are
*not* transferable to a new motherboard - check yours before starting),
unless the new motherboard is virtually identical (same chipset, same
IDE controllers, same BIOS version, etc.) to the one on which the WinXP
installation was originally performed, you'll need to perform a repair
(a.k.a. in-place upgrade) installation, at the very least:

How to Perform an In-Place Upgrade of Windows XP
http://support.microsoft.com/directory/article.asp?ID=KB;EN-US;Q315341

Changing a Motherboard or Moving a Hard Drive with WinXP Installed
http://www.michaelstevenstech.com/moving_xp.html

The "why" is quite simple, really, and has nothing to do with
licensing issues, per se; it's a purely technical matter, at this point.
You've pulled the proverbial hardware rug out from under the OS. (If
you don't like -- or get -- the rug analogy, think of it as picking up a
Cape Cod style home and then setting it down onto a Ranch style
foundation. It just isn't going to fit.) WinXP, like Win2K before it,
is not nearly as "promiscuous" as Win9x when it comes to accepting any
old hardware configuration you throw at it. On installation it
"tailors" itself to the specific hardware found. This is one of the
reasons that the entire WinNT/2K/XP OS family is so much more stable
than the Win9x group.

As always when undertaking such a significant change, back up any
important data before starting.

This will also probably require re-activation, unless you have a
Volume Licensed version of WinXP Pro installed. If it's been more than
120 days since you last activated that specific Product Key, you'll most
likely be able to activate via the Internet without problem. If it's
been less, you might have to make a 5 minute phone call.

--

Bruce Chambers

Help us help you:



They that can give up essential liberty to obtain a little temporary
safety deserve neither liberty nor safety. -Benjamin Franklin

Many people would rather die than think; in fact, most do. -Bertrand Russell
 
I have had some luck by fdisking the master boot record.

Boot to a bootable floppy with the fdisk command.
Afterit stops ant the "C" prompt enter fdisk \mbr
This will blow the boot record and allow a new one to be created but will
not damage your disk.
Good luck.
 
Back
Top