Monitor goes blank after logo screen..Radeon 9000

  • Thread starter Thread starter dustin
  • Start date Start date
D

dustin

Hi, everytime I install my Radeon 9000 in my computer and start it up
the monitor goes blank right after the Packard Bell logo screen that
gives the option for CMOS..even trying to go into CMOS won't work.
Whats the deal here?

my specs:
Packard Bell Model 8950
MSI MS-6156 Motherboard
NEC AMIBIOS VER 1.7
Pentium II 400mhz
ATI Radeon 9000 AGP 64MB
 
Hi, everytime I install my Radeon 9000 in my computer and start it up
the monitor goes blank right after the Packard Bell logo screen that
gives the option for CMOS..even trying to go into CMOS won't work.
Whats the deal here?
Click to expand...

Did you connect a molex PSU connector to the video card?
 
I dont think the 9000 require a power cable.

Have you checked to see if you can boot into safe mode? What monitor are you
using?
Make sure that the resolution and refresh rate you are booting up to are
within the monitors specs.
 
Use safemode or vga mode upon xp bootup.

Dominic Chin said:
I dont think the 9000 require a power cable.

Have you checked to see if you can boot into safe mode? What monitor are you
using?
Make sure that the resolution and refresh rate you are booting up to are
within the monitors specs.
Click to expand...
 
Back
Top