Missing Slave Hard Drive After XP Re-install

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

Greetings,

I just completed a re-install of XP and find that Windows doesn't show my
200 Gb Seagate. Prior to the re-stall both the "C" and "D" drives were
present. The "D" or "slave" does show during the BIOS sequence and I ran a
Seagate utility that also shows it's there. This sucks because I transferred
all of my "stuff" to it before wiping the "C" drive. Does anyone know of a
way to get Windows to identify the drive?

Any help is greatly appreciated.

Thanks -- Ray
 
Sounds as though one of them wasnt disconnected during the reinstall of xp,
you must physically disconnect it during an installation.However,try typing
cmd
in run,in cmd type:DiskPart In DiskPart type:list disk Type:list volume
See if it shows,type:HELP For all cmds You also,could type:diskmgmt.msc In
run..
 
Back
Top