Missing device in hardware macro

  • Thread starter Thread starter Doug Gordon
  • Start date Start date
D

Doug Gordon

Please refresh my memory on this. I used TAP.EXE to create a PMQ file for a
new target device. When I import this into Component Designer, I get several
lines like this:

Warning:Could not find a driver for Ethernet Controller
(PCI\VEN_8086&DEV_103A&SUBSYS_30118086&REV_82)

I know this means I have to go searching for yet more drivers and
componentize them, but after doing this should I rerun the PMQ import and
make a new, more complete hardware macro, or is it just as effective to
manually add the drivers to the configuration? I have done this in the past,
but can't remember how I've handled it before.

Doug G
 
It is a good step to re-run the import of the PMQ with a new log file to
verify that the inport is picking up the new driver components.

--
Regards,

Sean Liming
www.sjjmicro.com / www.seanliming.com
Book Author - XP Embedded Advanced, XP Embedded Supplemental Toolkit
 
Back
Top