Maxtor 30 gb not recognized

  • Thread starter Thread starter a
  • Start date Start date
A

a

I have a fairly new Maxtor ata 133, 30GB HD, that I just received a
few months ago as a replacement for an older HD that went to heaven.
On boot up, the HD shows as the secondary slave, but when Windows
comes on, the drives letters (E, F, G, H) do not appear. Does anyone
have any suggestions? Windows does not boot from this drive. I have
an old Fujuitsu 10GB that I put Windows and program files on.
 
I have a fairly new Maxtor ata 133, 30GB HD, that I just received a
few months ago as a replacement for an older HD that went to heaven.
On boot up, the HD shows as the secondary slave, but when Windows
comes on, the drives letters (E, F, G, H) do not appear. Does anyone
have any suggestions? Windows does not boot from this drive. I have
an old Fujuitsu 10GB that I put Windows and program files on.
Click to expand...

More info is needed....

Since you mention drive letters for it, i'll presume that you've
partitioned it? Did you format each partition?


Dave
 
Yes, each of the partitions was formatted and in use. There was quite
a bit of data on them. One morning I looked and a bunch of drive
letters had just disappeared.
 
Yes, each of the partitions was formatted and in use. There was quite
a bit of data on them. One morning I looked and a bunch of drive
letters had just disappeared.
Click to expand...

Maybe you're just unlucky, but it seems a bit odd that two drives have
had problems... perhaps an overheating, power supply, cabling, or IDE
controller problem?


Dave
 
Back
Top