Marvell vct not working

  • Thread starter Thread starter Brandon
  • Start date Start date
B

Brandon

i have an asus k8v-x motherboard with a built in Marvell 88E8001GbLAN
chip. The specs on the asus site says that the mobo supports the
virtual cable tester. But when i lauched the exe it won't allow to run
it. The "run" button is greyed out or lock or something. Should i
contact asus or the store where i bought the mobo from or is this a
software problem?
 
You must not be connected to a hub or other device that makes the link
active. The DSP must not be active for the test to work. The VCT help
file describes the resultant diagnostic messages after you run the utility.


PB
 
Brandon said:
i have an asus k8v-x motherboard with a built in Marvell 88E8001GbLAN
chip. The specs on the asus site says that the mobo supports the
virtual cable tester. But when i lauched the exe it won't allow to run
it. The "run" button is greyed out or lock or something. Should i
contact asus or the store where i bought the mobo from or is this a
software problem?
Click to expand...

Does VCT need some driver to be installed first ?

Paul
 
I am connected to a hub, and i am sure the hub is working because i get
a ip address from it. But its only a 10base hub, does that matter?
 
Paul said:
Does VCT need some driver to be installed first ?

Paul
Click to expand...

Yes it does, but i alrady installed the drivers. In fact the VCT
software i am using came with the drivers that i downloaded from asus
website.
 
I am connected to a hub, and i am sure the hub is working because i get
a ip address from it. But its only a 10base hub, does that matter?
 
i disconnected the calbe from my hub and then i laucnhed the calbe
tester and i was able to test it perfectly.
 
Back
Top