Make a Replica the Design Master

  • Thread starter Thread starter Matthew
  • Start date Start date
M

Matthew

I somehow misplaced my "design master" database; is there a way to convert a
replica into the design master?

Matthew
 
Hi,

My name is Amy Vargo. Thank you for using the Microsoft Access Newsgroups.

Open the replica that you want to make the new Design Master.
On the Tools menu, point to Replication, and then click Synchronize Now.
Select the current Design Master as the member to synchronize with.
Check the Make 'Filename' the Design Master check box.


I hope this helps! If you have additional questions on this topic, please
respond back to this posting.


Regards,

Amy Vargo
Microsoft Access Engineer


This posting is provided 'AS IS' with no warranties, and confers no rights.
You assume all risk for your use. © 2001 Microsoft Corporation. All rights
reserved.
 
That did it.

Something strange (but not as important), all of my querys, tables, etc,
have a yellow icon with two arrows. If I go to "properties" for any object,
under "type" it says "Table (Replicated)"

Is there a way to get rid of that?

Matthew
 
Hi Matthew,

My name is Amy Vargo. Thank you for using the Microsoft Access Newsgroups.

You will notice this as by design for a replicated database. You will also
notice that in your tables, you will have 3 fields that mark the table as
being replicated. This is so that synchronization can take place.

I hope this helps! If you have additional questions on this topic, please
respond back to this posting.


Regards,

Amy Vargo
Microsoft Access Engineer


This posting is provided 'AS IS' with no warranties, and confers no rights.
You assume all risk for your use. © 2001 Microsoft Corporation. All rights
reserved.
 
Back
Top