LMREPL.EXE is using 100% of the CPU

[Guest]

The LMREPL.EXE is using 100% of the CPU. Any ideas as to what maybe causing
this. There is nothing in the event veiwer that shows a problem.

 

[Galen]

In Burleyman <[email protected]> had this to say:

My reply is at the bottom of your sent message:

The LMREPL.EXE is using 100% of the CPU. Any ideas as to what maybe
causing this. There is nothing in the event veiwer that shows a
problem.

That's the replication service, is there a problem with the network between
the domain controllers? You said there's nothing in the event viewer to
indicate a problem... I take it that you need this service running and that
you're in a large environment? If so then if there's a scheduled down-time
or there's a problem with replication I'd suggest stopping the service and
restarting it when you can to see if that helps. Then again if you're not in
a situation where you need the service running you could always just disable
it.

Galen
--

"But there are always some lunatics about. It would be a dull world
without them."

Sherlock Holmes