Lexmark Z32 problem?

  • Thread starter Thread starter Kenny Ourso
  • Start date Start date
K

Kenny Ourso

I have a problem with my Lexmark printer. It will not power on. I have
confirmed that my power supply adapter is not the problem. I have power to
the printer, then nothing, no power/power light/no sounds. I am assuming
that I have a bad control circuit board or engine ??? I want to find
another control board for it or another broken printer to swap out the
board. Can anybody help me on this ?
Thanks, please reply ASAP
(e-mail address removed)
 
Thanks,
I called Lexmark and they say throw it away and buy "another one". I will
NOT, repeat NOT buy another product that is a throwaway, even though it
worked fine previously. I told them and emailed also to say I may take
their own advise and buy another printer BUT it will be a HP or something
else. They have a scam going with that mentality.
I have looked at ebay but no Z32s, I don't know if a Z31,33,25 will have the
same control board. Best bet will be another Z32.
 
Don't know why you couldn't find any Z32's on Ebay, I found quite a few, try
the link below. I don't know why you think Lexmark has a scam going, I
doubt whether HP, Epson or Canon would be able to provide you with the parts
you need to repair an entry level printer that's several years old and even
if they could I suspect that the price of the parts would far exceed the
cost to purchase a new printer.

http://tinyurl.com/2ddou
 
Back
Top