Laserjet 5 tray broke

  • Thread starter Thread starter Meese
  • Start date Start date
M

Meese

I have a Laserjet 5, it works fine, but I bumped the tray a little too
hard and the hinge broke. The manual describes it as "tray 1 and
extension". Does anyone know where I can find one of these?
The "rear access cover" is loose also and would like to get one of
them too while I am fixing the broken tray. I don't want to give the
printer up just because the flimsy tray is broken.

Thanks
 
Thanks for the response.
I was checking that page out, #5 and 1 from that page looks like what
I am needing. It's kinda hard to tell from their drawings though. What
do you think. Here's a scan from the manual with the needed part
highlighted
http://users.softcom.net/theos/lj5.jpg

Thanks again
 
Well . . .
Don't know if I'm going to be much help here but . . .
You said it was the hinge and the tray.

From what I can make out on their page it appears that part #100A-4A is the
hinge and yes it looks like 100A-1 Tray, MP, Extender LJ 5

and
100A-5 Door, MP LJ 5

are what you are looking for.

Hope the above formatting goes through.
Not having owned a LJ 5 myself I'm a bit stumped.
I guess I'd suggest the obvious which is to snap a digital photo of the
damage and email the place.
I'm sure they can help you better than I.
 
Meese,

I have a couple of LaserJet 5's that I use as parts machines.. Shoot me an
email with a picture or little better description of what you need and maybe
I can save you a few bucks on a used part..

Steve D.

(e-mail address removed)
 
Back
Top