To resolve this issue, use the appropriate method:
Boot Sector Virus
To determine if you have a boot sector virus, run a current virus-checking
program, and if needed, disinfect your computer.
Not a Boot Sector Virus
a.. View the System Log in Event Viewer for additional error messages that
help you determine the device that is causing the error.
b.. Bad block. Stop 0x77 is caused by a bad block in a paging file, or a
disk controller error, or in extremely rare cases it is caused when
non-paged pool resources are unavailable.
c.. If the first and second parameters are 0, then the stack signature was
not found in the kernel stack. The cause of this issue is defective
hardware. If the I/O status is C0000185 and the paging file is on a
SCSI-based hard disk, you should verify the disk cabling and SCSI
termination.
d.. If the I/O status code is 0xC000009C or 0xC000016A, this normally
indicates that the data could not be read from the disk due to a bad block.
e.. If you can restart your computer after the error message, Autochk runs
automatically and tries to map out the bad sector. If for some reason
Autochk does not scan the hard disk for errors, manually start the disk
scanner. If your computer is formatted with the NTFS file system, run Chkdsk
/f /r on the system partition. You must restart your computer before the
disk scan begins. If you cannot start your computer due to this issue, use
the Command Console and run Chkdsk /r.
f.. Defective or unreliable random access memory (RAM) is another common
cause of this issue.
g.. Verify that all the adapter cards in your computer are properly
seated.
h.. Ensure that all adapter card contacts are clean.
i.. Disable system caching in the BIOS to see if this resolves the error.
j.. If this does not resolve the issue, your computer mainboard
(motherboard) may be damaged.
source of information:
http://support.microsoft.com/default.aspx?scid=kb;en-us;315266&Product=winxp
Gwen7 said:
I am receiving error message, "Kernal_stack_inpage_error" . HOw do I
correct this problem?
