IPv6

  • Thread starter Thread starter Manoj
  • Start date Start date
M

Manoj

IPv6 gets installed by dafault when using SP2. Which component do I
have to remove from my TD configuration so that IPv6 is removed but
IPv4 is retained in the image? Will removing IPv6 have adverse
consequences on any dependent components used by IPv4? In short, I need
only IPv4 in my image.

Thanks
 
what I have done is put the following command in the phase 3498
snetcfg -u ms_tcpip6

I have never notice problem with IPV4.
I don't like manual operations, if I wanted to remove ipv6 in
TD, I must do a manual operation. and since adding ipv6 does
not increase too much image size, so I prefer uninstall it at
run time.

HTH

Zirong
 
Back
Top