ip4300 banding

  • Thread starter Thread starter DAVEJ
  • Start date Start date
D

DAVEJ

Hi, a friend has a nearly new ip4300 and it prints a half inch band normally
and the next half inch band faded and so on across the page. I had this on a
nearly new ip5300 and concluded that the presence of Inksaver on my pc was
the cause even though it had been uninstalled. Friend is currently doing a
fresh install but I wonder if anyone else has any ideas? This is happening
on plain paper and fast print settings in colour
 
DAVEJ said:
Hi, a friend has a nearly new ip4300 and it prints a half inch band
normally and the next half inch band faded and so on across the page. I
had this on a nearly new ip5300 and concluded that the presence of
Inksaver on my pc was the cause even though it had been uninstalled.
Friend is currently doing a fresh install but I wonder if anyone else has
any ideas? This is happening on plain paper and fast print settings in
colour
Click to expand...

Using the draft mode will often result in banding, this is not unusual. Run
the nozzle check test and report the results.
 
nozzle check tests were good. tia.
DanG said:
Using the draft mode will often result in banding, this is not unusual.
Run the nozzle check test and report the results.
Click to expand...
 
DAVEJ said:
nozzle check tests were good. tia.
Click to expand...



Then switch to "standard" print quality, there's shouldn't be any banding.
The "draft" setting is only intended for testing and lay-out work, it's not
intended to look pretty.

Occasionally, ink flow issues can be revealed in draft mode, as the flow is
inadequate for the faster print, but this is pretty rare. Dark or black
colors would be more likely to show this.

I highly recommend NOT using any 3rd-party "ink-saver" type software, as
it's just snake oil and does cause problems.
 
Back
Top