internet gateway, invoke router

  • Thread starter Thread starter Phil
  • Start date Start date
P

Phil

Please help, i cannot make the internet gateway icon appear in network
connections or network places. It used to appear in both these locations.

Is there a way to bring back the internet gateway icon? or a trick to invoke
a router with command line?

I am connected to a NETGEAR WGR614v9 wireless router. I am connected via
ethernet cable. the router has custom virgin media firmware. so i cannot
access any firewall setting, or find a default login and password to use.

So i either need to get the internet gateway icon back, or find a special
way to invoke a router. Any ideas? Thanks in advance!
 
Please help, i cannot make the internet gateway icon appear in network
connections or network places.  It used to appear in both these locations.

Is there a way to bring back the internet gateway icon? or a trick to invoke
a router with command line?

I am connected to a NETGEAR WGR614v9 wireless router.  I am connected via
ethernet cable.  the router has custom virgin media firmware. so i cannot
access any firewall setting, or find a default login and password to use.

So i either need to get the internet gateway icon back, or find a special
way to invoke a router.  Any ideas?  Thanks in advance!
Click to expand...

The Internet gateway icon "usually" appears when the UPNP option is
enabled on most routers.
 
Thanks for the suggestion. I know the router supports Upnp because the icon
has appeared in the past. but since the router has custom firmware theres no
obvious option to change any router setting at all. so i cant manually
change any of the router setting, unless i can invoke the router to change
its firewall exceptions for programs and ports. Any other ideas?
 
Thanks for the suggestion. I know the router supports Upnp because the icon
has appeared in the past.  but since the router has custom firmware theres no
obvious option to change any router setting at all.  so i cant manually
change any of the router setting, unless i can invoke the router to change
its firewall exceptions for programs and ports.  Any other ideas?






- Show quoted text -
Click to expand...

The original style firmwares all had a web page accessable with any
browser by using the default gateway IP address (ipconfig) as the
address.
 
Pastor Dave said:
Since you top posted (no offense, but it's rude in usenet),
I didn't read the whole post. But FYI, personally, I don't
use uPnP, because it has security holes. But what kind of
router do you have, that doesn't allow for configuration?

Are you sure that's it and not you just not knowing how?
Click to expand...

Ok, sorry didnt know about the top posting thing.
So, im going to just buy a router that works the way i want it to. I think
this router with custom virgin firmware is brutally limited as to setting up
networks how one would normally. Thanks for the suggestions and advice. I
think my problem is the router, so...

Solution: replace router!

I was thinking of flashing the router with original firmware somehow. its a
good router and a shame to be let down by such bad virgin firmware. Anyway ,
thanks to you all again,
 
Ok, sorry didnt know about the top posting thing.
So, im going to  just buy a router that works the way i want it to.  I think
this router with custom virgin firmware is brutally limited as to settingup
networks how one  would normally.  Thanks for the suggestions and advice.  I
think my problem is the router, so...

Solution: replace router!

I was thinking of flashing the router with original firmware somehow. itsa
good router and a shame to be let down by such bad virgin firmware.  Anyway ,
thanks to you all again,- Hide quoted text -

- Show quoted text -
Click to expand...

Flashing the router is usually done withon the web pages of the router
configuration. If you can not acces these, then it may not be
possible to flash it.
 
Back
Top