Intel RAID 82801ER ICH5R = BSOD stop 7

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

Attempting boot from DVD clean install RC1 on RAID 0 with Intel 82801ER ICH5R
controller. As soon as driver loaded in setup = BSOD STOP: 0x0000007E
(0xC0000005, 0x8883D6AC, 0x843E7890, 0x843E758C). Using Intel driver ver
4.1.0.6325. Will try latest Intel driver 5.0.0.1032.
 
Intel sata driver ver 5.0.0.1032 = BSOD STOP: 0x0000007E (0xC0000005,
0x8883D6AC, 0x843EB890, 0x843EB58C)
Intel sata driver ver 6.1.0.1002 loaded but does not support the 82801ER
ICH5R controller. no BSOD.

Will try to install from inside XP
 
Install from inside XP was successful. Intel RAID driver 5.0.0.1032. Dual
boot XP & RC1 on RAID 0.
 
I am attempting a clean install of RC1. I have a Intel 82801ER, and receive
the exact same BSOD fault code when the RAID driver installs. Exactly! Did
you ever figure a way to do clean install and load the driver? I have a
D875PBZ and Intel says they will no longer support the board. I had no
problems loading the RAID driver within Beta2. Thanks for any Info, and Help.
 
The only way I could install 5600 was to install dual boot and start the
installation from inside XP.

The good news is that I just installed 5728 clean (boot from DVD) with no
problems what so ever. I used Intel F6 driver ver 5.0.0.1032

Good luck
 
I know this post is nearly a month old but I can't find the 5.0.0.1032 driver
you say you used during the installation. I have searched all over the Intel
site for it but just can't seem to hit the right download page to get the
driver for a floppy.

I am getting the blue error screen with the Win XP driver 3.50.2568

Thanks for any help you can provide.
 
Back
Top