M
mottebelke
To setup my device after a hard reset I made a config app which runs
from a SD card. One of the steps is to install the CF SP3 (by calling
wceload.exe).
This starts fine, but then comes up with messages saying that some
files are in use (cgautil, mscoree.dll, etc.) and it can't overwrite
them. I guess it's because my config app uses these (CF)files to run.
Is there any way to avoid this? Can I deploy the CF DLLs with my app so
it uses those to run and not the ones already on the device?
Or is the only way to copy the CAB to the startup folder and do a soft
reset?
from a SD card. One of the steps is to install the CF SP3 (by calling
wceload.exe).
This starts fine, but then comes up with messages saying that some
files are in use (cgautil, mscoree.dll, etc.) and it can't overwrite
them. I guess it's because my config app uses these (CF)files to run.
Is there any way to avoid this? Can I deploy the CF DLLs with my app so
it uses those to run and not the ones already on the device?
Or is the only way to copy the CAB to the startup folder and do a soft
reset?