Installation error

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I need some help. I'm lost trying to install Windows 2000 Pro as an upgrade
but the installation hangs during the "Installing Devices" section. I get the
following error message: "Windows could not load the installer gfor Net.
Contact your hardware manufacturer...." I get the same error message for
NetClient, NetService,NetTrans and infrared. Also it "cannot" load
ADSLDPC.DLL. After clicking OK to all the error messages the "Installing
Devices" section ends, the computer reboots and the loop starts again. I've
already converted from FAT32 to NTFS so I can't go back to 98. Anyone have
any suggestions? Thank you in advance for your time and effort. - Eric
 
Be advised that upgrades from win9x almost always fail for any number of
reasons. Save yourself some time and trouble, given that you'll more than
likely end up with an unstable OS with all the remnants/ corruption left
behind from the upgrade. Best to blow it all away and go for the clean
install.

To do a clean install, either boot the Windows 2000 CD-Rom or setup disks.
The set of four install disks can be created from your Win2k CD-rom; change
to the \bootdisk directory on the cd-rom and execute makeboot.exe (from dos)
or makebt32.exe (from 32 bit) and follow the prompts.

When you get to the point, delete the existing NTFS and or other partitions
found. After you delete the partition(s) abort the install, then again
restart the pc booting the CD-Rom or setup disks to avoid unexpected drive
letter assignments with your new install.

During Windows 2000 setup, at some point, will want to confirm the previous
operating system for the upgrade; at that point you'll simply insert the
qualified product install CD for it to verify. Then the install will
proceed.

Check the pc, mb or hardware manufacturer's web site for the latest bios and
or Windows 2000 drivers for your devices.

Be sure to apply these to your new install before connecting to any network.
http://download.microsoft.com/download/E/6/A/E6A04295-D2A8-40D0-A0C5-241BFECD095E/W2KSP4_EN.EXE

Rollup 1 for Microsoft Windows 2000 Service Pack 4
http://support.microsoft.com/kb/891861


--

Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect

:
|I need some help. I'm lost trying to install Windows 2000 Pro as an upgrade
| but the installation hangs during the "Installing Devices" section. I get
the
| following error message: "Windows could not load the installer gfor Net.
| Contact your hardware manufacturer...." I get the same error message for
| NetClient, NetService,NetTrans and infrared. Also it "cannot" load
| ADSLDPC.DLL. After clicking OK to all the error messages the "Installing
| Devices" section ends, the computer reboots and the loop starts again.
I've
| already converted from FAT32 to NTFS so I can't go back to 98. Anyone have
| any suggestions? Thank you in advance for your time and effort. - Eric
 
Back
Top