Insert Signature Image

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

Hello,

I need to insert a signature into a report. I started playing around with
it, but was hoping to save some time by learning from someone else's
experience.

Which is a better way to go about it? Scan a signature or just create a
jpeg in Adobe photoshop? Or something else?

When I inserted a test image, the image obscures the 'Sincerely' above
and/or printed name below. Adjusting the size of the image results in a
ridiculously small signature. Is there a 'bring to front' type option for
controls? If not, any suggestions?

As always, thank you.
 
The best way to do this is scan you signature, cut it in some Photo editor so
it doesn't take the entire page only the portion of signature, then in Report
design view click on Insert -> Picture and put it below Sincerely and between
the name. If the signature is static this is the best way to do it. However,
if the signature is dynamic you can create a signature table and store the
name and jpeg in the table and depending on whose signature you want to
display you can recall from there.
 
Back
Top