Insert Picture into Form

  • Thread starter Thread starter Striker
  • Start date Start date
S

Striker

I have created a template and unlocked one section of it where I hope the
user will insert a picture of MS Project. However whenever a picture is
inserted into the section, it shows up as only a sliver of the original, and
can not be adjusted. In other words if the snapshot is 4 inches tall the
inserted version shows up as only an 1/8 inch tall in the unprotected
section.

I have left plenty of room in the unprotected part of the DOT. Any ideas
what could be wrong?

Thanks
 
Hi Striker,
I have created a template and unlocked one section of it where I hope the
user will insert a picture of MS Project. However whenever a picture is
inserted into the section, it shows up as only a sliver of the original, and
can not be adjusted. In other words if the snapshot is 4 inches tall the
inserted version shows up as only an 1/8 inch tall in the unprotected
section.

I have left plenty of room in the unprotected part of the DOT. Any ideas
what could be wrong?
Click to expand...
You don't mention which dimension the "sliver" is coming from (top, side...).
But you could check the line spacing setting for the unprotected paragraph in
this section (Format/Paragraph). If it's set to "Exact" that would explain the
top or bottom getting cut off.

Cindy Meister
INTER-Solutions, Switzerland
http://homepage.swissonline.ch/cindymeister (last update Jun 17 2005)
http://www.word.mvps.org

This reply is posted in the Newsgroup; please post any follow question or reply
in the newsgroup and not by e-mail :-)
 
You have inserted the picture into a paragraph with Exactly line spacing or
into a table row with Exact row height.

--
Suzanne S. Barnhill
Microsoft MVP (Word)
Words into Type
Fairhope, Alabama USA

Email cannot be acknowledged; please post all follow-ups to the newsgroup so
all may benefit.
 
Thank You, I'll take a look at that, and it is the Height that is the
problem, not the width
 
Back
Top