IEEE1394 code 10

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I installed a NEC IEEE 1394 it says this device cannot start (code 10) i have
tried uninstalling and reinstalling it but with no luck,,any ideas?
 
Tami said:
I installed a NEC IEEE 1394 it says this device cannot start (code 10) i have
tried uninstalling and reinstalling it but with no luck,,any ideas?
Click to expand...


What is the make of the system or the motherboard? Are the
USB drivers installed and USB is working? The software for
it is usually on the motherboard or an utilities cdrom.
 
sorry for the lack of information new at this. so hoefully i am now giving
you the right information. This is a card which i put into an empty slot.
It has P1394A OHCI link and PHY core function, compliant with IEEE 1394-1995
standard for high proformance Serial Bus, supliment 4.0, Complies with 1394
OpenHCI specifications V1.0 and V1.1, compliant with PCI specification 2.2.
Got all the above information from the box.
I did get the error message (code 10) from the device manage, when deleting
and reinstalling it via the device manage the computer does find the new
hardward but the an exclamation mark in a yellow square appears by the side
of the description of it. again in Device manager.
Not sure if its a PCMCIA card or PCI card .
Again i apoligise if my question is still vague theres alot i dont
understand, but i have had this problem since i installed it 5 months agao
and would appreciate any help.
Thank you
Tami
 
A big thank you to Treeman I followed your instructions and now i can finally
use the i pod.

Thanks again

Tami
 
Back
Top