IEEE 1394 problem

  • Thread starter Thread starter Skjoldmø
  • Start date Start date
S

Skjoldmø

Is it possible to connect the 6 individual pins from the firewire port in
the front bezel to a 10-pin connector on the motherboard.
MB(P4C800 deluxe) Bezel
connectors(Antec P160)
TPA0+ TPA0- TPA+
TPA-
GND GND
? ?
TPB0+ TPB0-
TPB+ TPB-
+12V +12V
? ?
GND
? ?


Only 1 VP for power and 1 VG for ground pin
So where do I put them or can it not be done ?
TIA Skjoldmø
 
Is it possible to connect the 6 individual pins from the firewire port in
the front bezel to a 10-pin connector on the motherboard.
MB(P4C800 deluxe) Bezel connectors(Antec P160)
TPA0+ TPA0- TPA+ TPA-
GND GND ? ?
TPB0+ TPB0- TPB+ TPB-
+12V +12V ? ?
GND ? ?
Only 1 VP for power and 1 VG for ground pin
So where do I put them or can it not be done ?
TIA Skjoldmø
 
I'm pretty sure you connect the data as you have them in your diagram and
just connect power to any of the 12v pin and same as the ground. From what I
understand the power pins run from the same source annd likewise with
ground. Hope this helps.
 
Back
Top