I need help as my router looses connection to Windows XP

  • Thread starter Thread starter M. B.
  • Start date Start date
M

M. B.

I will try to make this as short as possible. For some reason, my router
(Netgear WGR614v3) keeps loosing the connection to my Windows XP SP1,
causing me to loose my DSL connection for about 10 - 30 seconds. Then as if
nothing happened, I am back online. This happenes randomly (sometimes twice
a day, and sometimes more) I know that it is not a defective router, as
I had a D-Link 624 before that, and I have already exchanged my Netgear
twice (trying different BIOS version and tec). All lead to the same
symptom: A little popup box at the bottom right tells me that the LAN cable
has been unplugged (which is not the case). Please remember: Although I
have a WIRELESS router, this lost connection happens on the machine that is
physically connected to the router, so this has nothing to do with wiresless
reception.

I have tried everything I can think of but perhaps someone else has an idea
of what to do? Just for the record, before installing a router I was
running my DSL modem (Verizon) as a router and NEVER had these problems for
over 2 years! The fact is that if I loose my connection to the internet
even for 5 seconds, my Java applets which run in real-time lockup and I have
to restart my whole system.

Here is my system: ASUS P4C800 Deluxe motherboard, which has a 3COM Gigabit
LOM (3C940) network adapter card. I am running the latest known driver
version 1.0.0.46. My DSL modem is a Westell 2200 (latest firmware), whcih
is running in bridge-only mode. I even got another Westell to test the
issue, but the same story.

Without question, the problem seems to be somwhere between my NIC, Router
and Windows XP. It is definately not DSL related since if I plug the
Westell directly to the PC, I never have (had) these issues. One last
point: I have re-checked the router setup and I have the "always" log'ed in
option on. In any case, if my router would log me off my Verizon DSL
account, I would not be getting this "LAN cable unplugged" system tray
pop-up.

And help/suggestions would be VERY MUCH appreciated!
 
First of all, thank you everyone for the different suggestions. Here is
what I have tried:

1) Disabled the onboard 3Com Gigabit LOM (3C940) Network card (via the
motherboard BIOS)
2) Installed a Netgear Fast Ethernet FA310TX network card, which worked fine
for over 2 years before. It is set to Auto-Sensing speed, Threshhold=256
bytes and burst length is 16 DWORDS.
3) Made sure that the MTU is set to 1492 and disabled UPnP on the router.
4) Double-checked that each CAT-5 cable to make sure it is working fine. I
even replaced two of them and then pulled and tugged them to see if any of
these might cause this disconnection problem, but I could not replicate the
issue described below
5) And yes, my Westell Verizon DSL modem is running in bridge-only mode.
6) As far as I can tell, this cannot be some kind of a power-saver feauture
issue, as I have lost connections while I was typing and when the monitor
was in "screen saver" mode.

But alas, I am still having the same issue. Every few hours I get that
"LAN cable has been unplugged" system tray icon pop up at the bottom right
and I loose the internet connection. Give it about 20-30 seconds, and I
am again auo-reconnected to the internet.

One other thing: Some of you have mentioned that the 2.4Ghz phone sometimes
cause havoc, but I again remind you that my issue has nothing to do with
wireless interruptions. This is happening on the machine to which the
router is physcially connected.

I am open to hear any other ideas.
 
Well, I can't help, but I have a problem with my router renewing the
IP address every few minutes. The router log clearly shows the
renewal. But, it is almost transparent to my use of the internet and
E-Mail. Once in a while, I notice a slight delay when the renewal
occurs just as I request a new page, etc.

Good luck, jimbo
 
I have been battling this issue now for a week, and just came up on
something
interesting:

As suggested by some, I disabled the "Wirless Zero Configuration" services,
and within 10 minutes of the reboot, I again lost the LAN connection. I
went inside the Manage | System Event Log and found this first entry (under
TCPIP) :

The system detected that network adapter
\DEVICE\TCPIP_{143B8F42-637C-404C-BA9D-ED75774914C4} was disconnected from
the network, and the adapter's network configuration has been released. If
the network adapter was not disconnected, this may indicate that it has
malfunctioned. Please contact your vendor for updated drivers.

*** and only 5 second later, another entry ***

The system detected that network adapter
\DEVICE\TCPIP_{143B8F42-637C-404C-BA9D-ED75774914C4} was connected to the
network, and has initiated normal operation over the network adapter.

*** ALSO *** I actually got to watch the router (Netgear WGR614v3) during
one of these "disconnects" from the LAN and saw that it looked like it was
turned off and then turned back on again (almost all of the lights went
dark, except the POWER light) and then re-sync'ed). I would love to tell
you that it might be a
defective router, but this is a SECOND one of this kind that I am trying
with the same symptom.

I have also re-checked but my "current" NIC card does not have any
power-suspend mode (or sleep mode), so this cannot be the case. And
lastly, my router does not have any "lease expiration" options so it cannot
be this (especially that sometimes my connection holds 2 hours, and
sometimes just 15 minutes)

So, I am back to first base. For sure it cannot be bad cables (tried 5
different ones), bad router (tried 5 different ones from 3 different brands
Linksys, D-Link and now Netgear) and bad NIC card (tried two different
ones).

Thanks again everyone!
 
M. B. said:
I have been battling this issue now for a week, and just came up on
something
interesting:

As suggested by some, I disabled the "Wirless Zero Configuration" services,
and within 10 minutes of the reboot, I again lost the LAN connection. I
went inside the Manage | System Event Log and found this first entry (under
TCPIP) :

The system detected that network adapter
\DEVICE\TCPIP_{143B8F42-637C-404C-BA9D-ED75774914C4} was disconnected from
the network, and the adapter's network configuration has been released. If
the network adapter was not disconnected, this may indicate that it has
malfunctioned. Please contact your vendor for updated drivers.

*** and only 5 second later, another entry ***

The system detected that network adapter
\DEVICE\TCPIP_{143B8F42-637C-404C-BA9D-ED75774914C4} was connected to the
network, and has initiated normal operation over the network adapter.

*** ALSO *** I actually got to watch the router (Netgear WGR614v3) during
one of these "disconnects" from the LAN and saw that it looked like it was
turned off and then turned back on again (almost all of the lights went
dark, except the POWER light) and then re-sync'ed). I would love to tell
you that it might be a
defective router, but this is a SECOND one of this kind that I am trying
with the same symptom.

I have also re-checked but my "current" NIC card does not have any
power-suspend mode (or sleep mode), so this cannot be the case. And
lastly, my router does not have any "lease expiration" options so it cannot
be this (especially that sometimes my connection holds 2 hours, and
sometimes just 15 minutes)

So, I am back to first base. For sure it cannot be bad cables (tried 5
different ones), bad router (tried 5 different ones from 3 different brands
Linksys, D-Link and now Netgear) and bad NIC card (tried two different
ones).

Thanks again everyone!
Click to expand...

I hate to state the obvious, but is sounds like your router is resetting
itself. And to state even more obvious (don't take offense), but do you
perhaps have it plugged in into an overloaded AC outlet, thus experiencing a
brown out?
 
Jerry,

I tried 2 different plugs and 2 different outlets, and the same story.

These are the same plugs/outlets that have NEVER caused any problems like
this, even during the summer months.

I would have to rule this one out.
 
Okay, a shot in the dark.... how well is your router protected against
external attacks? I have dynamic IP but even so, if I've had the same IP for
a long period of time I see an almost constant barrage of attacks, mostly
Ping-of-death and SYN floods, in the router logs. Some routers will
crash/reboot, as you described your symptom, when attacked by SYN floods.
There may be other types of attack which do the same thing.
 
I am happy to report that after 8 days of constant battles, reboots, phone
calls, cable pulling, router changing, it seems that I finally have found a
combination that has had me using Verizon DSL account for over 12 hours so
far without any kind of interruptions.



Since so many of you tried giving me comments and suggestions, I felt that
it is necessary for me to post this here so that the next person will not
(hopefully) need to go through this hell as I did!



My original problem was that when after I purchased a D-Link Wireless Router
DI-624, I would get disconnected from Verizon DSL at least once every 2
hours or so. My internet access would "freeze" and then a little popup box
at the bottom right system tray would tell me that the "LAN cable has been
unplugged". After about a minute or so, my internet connection would be
back working This was NEVER happening during the 2+ years I was using my
Westell modem alone (running in router mode).

Please keep in mind: The problem I was having was not wireless related as
it was happening to the desktop computer to which the router/westell was
connected to!


During these last 8 days, I tried: one DI-624 wireless router, two Netgear
614v3 routers and two Linksys WRT54G v.2 routers. In addition, I received a
brand new Westell 2200 modem from Verizon. I also tried about four
different CAT-5 cables. Here is the final outcome:



I have the Linksys WRT54G (version 2) wireless router connected to the
Netgear Fast Ethernet FA310TX network card in Auto-Sense mode (using the
built-in XP drivers, as Netgear told me that there was never a newer
revision released). I have DISABLED the built-in 3Com Gigabit LOM (3C940)
network card (via the ASUS P4C800 Deluxe motherboard BIOS), DISABLED the
Zero Wireless Configuration service, and have put in the IP/Gateway/DNS
address numbers inside my Windows XP Network Connections | LAN setup. My
operating system is Windows XP Pro SP1 and the modem is a Westell 2200
configured as bridge only.



If my situation continues to be stable, I *might* try to go back to the 3Com
built-in card (disable any power management) and then re-enabling the Zero
Wireless Configuration services. But in reality, I am happy with the way
things are and have already spent enough time trying to get my router to
work with Verizon DSL without having it drop connections!



Now, the next step will be setting up the WIRELESS part of this. I don't
even yet have a laptop with me on the premises, but the 802.11g card that I
already have is the D-Link DWL-G650. I hope and assume that this will work
okay with the Linksys...



One thing I must say is that I never realized that how many problems other
users are having. I would have thought that since 802.11x has been around
in the mainstream by now 2+ years, that things would have been much more
"system friendlier". And again, my issues were not even WIRELESS related.
All 3 tech supports were not really helpful, as none of them realized that
the problem is somehow between the router and Windows XP (Ethernet card?)
loosing a connection, which of course results in Verizon DSL loosing the
connection also.



One other comment about the Netgear 614 v.3 router: A number of people have
responded to tell me that they have had this random "router resetting"
happen to them (where the routers behaves as if someone turned the power off
and then back on, and the lights flash) just as if you first turn it on). I
was lucky to witness it myself during one of the "disconnects" that I had.
This was actually the reason why I went back to try the Linksys one more
time. So, I would definitely recommend staying way from this 614 (version
3) model.



Once again - THANK YOU everyone!
 
Back
Top