I Have uDOC a problem

  • Thread starter Thread starter Kwon Daewook
  • Start date Start date
K

Kwon Daewook

Hi!

I have purchased uDOC from M-systems.

I have added uDOC component in the SLX being used in hard disk.
And then I have checked dependence and done building OS and copied uDOC.
OS is halted before FBA running.
Disk check is where OS is halted.
After /sos in boot.ini is added, I could see where OS is halted.

It works properly when I have built using Macro component provided by
M-Systems.

There is no logo left since it has been stopped before entering FBA..
I am in very an embarrassing situation.

Please help me !!
 
Hi Kwon,

Please contact me on email so that I can help you more.

But here are few basic steps that you can try:
1. Try adding "PnP (User Mode)" component to your image if not there.
2. Try adding macro component to your project. Resolving dependencies and then removing macro component. If you still have a problem
you can try removing all USB related components before adding macro component again and resolving dependencies.

1. Send me windows\system32\config\system. file (the one without extension) from your image.
2. Let me know about the BSOD error that you see. Or any other error for that matter.

Regards,
Slobodan
 
Back
Top