J
Just Wondering
Prints to right more than it should, letters get cut off..any help?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
T
Terry Fcukwit
I have just bought a secondhand Kyocera FS-600 (the delights of Ebay!).
When I power it up the on line and data lights go on for a bit, all the
lights go on in succession, then go out leaving the 'cassette' and 'jam'
lights flashing. Naturally I can't print anything. I've opened all the
hatches I can, and it does it with paper loaded and without.
I also took the toner out to see if there was anything I could see with
it removed, put it back in, and now the toner light is always on unless
I lift the front panel up very slightly.
I've hunted around online for manuals, but the FS-600 doesn't even
appear in Kyocera's legacy section!
Any ideas?
When I power it up the on line and data lights go on for a bit, all the
lights go on in succession, then go out leaving the 'cassette' and 'jam'
lights flashing. Naturally I can't print anything. I've opened all the
hatches I can, and it does it with paper loaded and without.
I also took the toner out to see if there was anything I could see with
it removed, put it back in, and now the toner light is always on unless
I lift the front panel up very slightly.
I've hunted around online for manuals, but the FS-600 doesn't even
appear in Kyocera's legacy section!
Any ideas?
C
Cullinane
Prints to right more than it should, letters get cut off..any help?
What's the model?
J
Just Wondering
Its a photosmart 1215
Cullinane said:What's the model?
S
spock
Terry Fcukwit said:I have just bought a secondhand Kyocera FS-600 (the delights of Ebay!).
When I power it up the on line and data lights go on for a bit, all the
lights go on in succession, then go out leaving the 'cassette' and 'jam'
lights flashing. Naturally I can't print anything. I've opened all the
hatches I can, and it does it with paper loaded and without.
I also took the toner out to see if there was anything I could see with
it removed, put it back in, and now the toner light is always on unless
I lift the front panel up very slightly.
I've hunted around online for manuals, but the FS-600 doesn't even
appear in Kyocera's legacy section!
Any ideas?
Welocome to the club, though my printer worked for a while at first. I
stripped it down, and cleaned all the gears etc. then put it back
togther again...I suspect the toner cartridge holder connectors are
dodgy but cant say for sure.
It prints now, but with ghost images and sounds like its in a lot of
pain when printing...what a waste of money (I bought 3 toner
cartridges as well)...shame.
I managed to find a user manual from their American website, but it
doesnt go into fault fixing, though it does tell you what
flashing/blinking light combinations mean.
Don't rush out and buy more toner yet.