How to unlock / turn on RPC for windows2000 SP4 professional

  • Thread starter Thread starter 123
  • Start date Start date
1

123

Dear All,

Problem about RPC (remote procedure call) - need help urgently

I am using windows 2000 sp4 profession. Expect my computer was inflected by
Blaster Worn and computer keep on restart.

After I enter services.msc and select stop use RPC and install
Windows2000-KB823980-x86-CHT.exe and reboot the computer. The auto
restart is fixed.

BUT a serious problem come up! when I enter services.msc and try to re-set
the RPC to auto mode, found it is locked and not allow me to change the
RPC setting. Also I can't conncet to internet.

Can you please advise how to unlock / turn on RPC for windows2000 SP4
professional

Many many thx for your advise.
 
From the recovery console command prompt;

enable rpcss service_auto_start

To start the Recovery Console, start the computer from the Windows 2000
Setup CD or the Windows 2000 Setup floppy disks. If you do not have Setup
floppy disks and your computer cannot start from the Windows 2000 Setup CD,
use another Windows 2000-based computer to create the Setup floppy disks.
Press ENTER at the "Setup Notification" screen. Press R to repair a Windows
2000 installation, and then press C to use the Recovery Console. The
Recovery Console then prompts you for the administrator password. If you do
not have the correct password, Recovery Console does not allow access to the
computer. If an incorrect password is entered three times, the Recovery
Console quits and restarts the computer. Note If the registry is corrupted
or missing or no valid installations are found, the Recovery Console starts
in the root of the startup volume without requiring a password. You cannot
access any folders, but you can carry out commands such as chkdsk, fixboot,
and fixmbr for limited disk repairs. Once the password has been validated,
you have full access to the Recovery Console, but limited access to the hard
disk. You can only access the following folders on your computer: drive
root, %systemroot% or %windir%


--
Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect

:
| Dear All,
|
| Problem about RPC (remote procedure call) - need help urgently
|
| I am using windows 2000 sp4 profession. Expect my computer was inflected
by
| Blaster Worn and computer keep on restart.
|
| After I enter services.msc and select stop use RPC and install
| Windows2000-KB823980-x86-CHT.exe and reboot the computer. The auto
| restart is fixed.
|
| BUT a serious problem come up! when I enter services.msc and try to
re-set
| the RPC to auto mode, found it is locked and not allow me to change the
| RPC setting. Also I can't conncet to internet.
|
| Can you please advise how to unlock / turn on RPC for windows2000 SP4
| professional
|
| Many many thx for your advise.
|
|
 
Back
Top