How to set form size?

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

My form is little smaller than the screen. However, upon launch, the
forms length becomes bigger and Access Record information
on shows at the bottom of the screen, I would like the Access
record information to appear where the form ends.

How can I specify this?

Thank you,
-Me
 
Rick,

I already did that and it works just fine. The only problem
I have as stated is that the Access Status line
Record << < 1 > >> appears too much below the form
that forces to open the complete window.

I would like even this to appear where the form ends.

I hope its clear now.

Thank you,
-Me
 
The record selector appears at the bottom of the form. If there is too much
space between your form data and the record selectors, then you need to make
your form smaller.

Rick B
 
Rick,

That's the question I have how do I make the form size
smaller? I have designed the form, that appears to be small
but when I launch it, there is lot of space between
the form and the record selector. How do I short it in
design view? I don't have space.

Thank you for your time!
-Me
 
Back
Top